Abstract
The load-bearing capacity and failure types of indirect inlay-retained fixed dental prostheses (FDP), made of particulate filler composite (PFC) (Estenia) alone or reinforced with E-glass fibers impregnated with various monomers were evaluated. Indirect inlay-retained FDPs were made between first premolars and first molars (N=30, 10/per group). The inlay parts of the specimens were silica coated and silanized and the specimens were cemented with dual-polymerized resin cement under ultrasonic vibrations. The experimental groups were as follows: Group 1: FRC1 (BR-100, UTMA) + PFC; Group 2: FRC2 (everStick C&B, Bis-GMA/PMMA) + PFC; Group 3: PFC only. The specimens were kept in distilled water at 37 °C for one month and then subjected to fracture strength test. No significant difference was found between the Group 1 and Group 2 FDPs (1357±301 N and 1213±316 N, respectively) (p>0.05) (ANOVA). Group 3 (856±299 N) showed significantly lower results than those of FRC reinforced groups (p<0.05). Failure analyses revealed no debonding of any of the FDPs from the inlay cavities. FDPs made of PFC only showed mainly catastrophic fracture of the pontic. In the FRC reinforced groups, predominantly delamination of the veneering was observed. The use of silica coating and silanization in combination with the dual-polymerized resin cement used; under ultrasonic cementation procedure provided sufficient adhesion to withstand static loading forces at the cementation interface, since the failures were predominantly delamination of the veneering in the FRC reinforced groups.
Özcan, Mutlu